Publicidad
Save the changes.
8.1.7.2
Triggers
Under Setup card header-> Select Other Card-> Trigger
Multi-Function Button
● Tap Action
Defines the operation when the MFB on the tool is tapped (pressed quickly).
● Hold Action
Defines the operation when the MFB on the tool is held for one second.
The MFB Mode configures the multiple function button for handheld QPM tools. The button can be configured to
operate in any of the following modes.
Options
Description
Disable
The button does nothing.
Reverse
Pressing the button toggles between assembly and disassembly and illuminates the
appropriate blue light. All tool status lights flash when the tool is in disassembly mode.
(Disassembly)
Job/Task Select
Pressing the button toggles between Job/Task 1 and Job/Task 2 and illuminates the
appropriate orange light.
Arm
Pressing the button arms (activates) the trigger but does not start the tool with a
message 'Not Armed". The blue assembly light comes on to show that the tool is armed
for three seconds.
Reset Reject
This function, when selected, will cause the tool to disable after a NOK Fastening cycle
with a message 'Not Armed". The Reject Tone, when enabled, will sound. Pressing the
button re-enables the tool indicating the operator acknowledges the rejected Fastening
cycle and wishes to repair it.
Job Reset
Pressing the button causes the selected Job to be reset. This means that the fastener
count is reset and the tool, if disabled due to Error Proofing requirements, re-enables.
Reset and Reverse
This function, when selected, causes the tool to disable after a NOK Fastening cycle.
The Reject Tone, when enabled, will sound. Pressing the button re-enables the tool in
the Reverse direction and indicates that the operator acknowledges the rejected
Fastening cycle and wishes to repair it. Press MFB button to switch the tool in forward
direction.
Lever
● Start Mode
Defines which input starts the tool. In all cases, the 24V DC Start input is always available to start the tool.
● Lever
Only the trigger on the tool starts the tool.
● None
Neither the tool trigger nor the tool push-to-start switch starts the tool.
Save the changes.
8.1.7.3
Lights
Under Setup Card header -> Select Other Card -> Lights
SC Series Controllers
Configuration
87 / 1032
Publicidad
