Publicidad
SC Series Controllers
Operation
7.6.1.2
Spindle display
1
2
3
1 Red
3 Yellow
5 Torque
7 Angle
9 Active Task number
11 Target batch count
The colours indicate status of the fastening cycle for spindle 1:
● Red indicates high torque/angle [1]
● Green indicates an OK fastening cycle [2]
● Yellow indicates low torque/angle [3]
● Blue indicates when the tool is enabled to run [4]
A Shutoff codes is also displayed when applicable [12].See Chapter Shutoff codes [} 127]
Touch on a spindle to view setup, service and analyze menus.
The display background colour turns red in the event of a fault or NOK fastening cycle.
The run display changes to indicate the step in which the tool stopped (providing it did not stop during the audit
step).
36 / 1032
OPEN Connected
Toolsnet Connected
ToytotaPI Connected
4
6
12
The controller is connected to an
OPEN protocol server.
The controller is connected to a
Toolsnet protocol server.
The controller is connected to a
ToyotaPI protocol server.
8
7
2 Green
4 Blue
6 Step name
8 Active Job number
10 Acumulated bolt count
12 Shutoff code
9
10
11
Publicidad
