Descargar Imprimir esta página

Stanley SC Serie Manual De Instrucciones página 58

Publicidad

SC Series Controllers
Configuration
For controllers with TOOLSNET, the plant's IT department must provide these values to allow the SC controller
to communicate on the TOOLSNET protocol network. The One Box controller will communicate only with a
TOOLSNET server that employs a PIM server (i.e. World Version 7).
Server IP
Type the IP Address of the TOOLSNET server on the network.
Port
The required virtual port on which to communicate this protocol. For the SC controller it is normally 6575.
System
Type the cell number where this SC controller resides.
System Name
Type the system number where this SC controller resides
Station
Type the Station number where this SC controller resides.
Station Name
Type the Station name where this SC controller resides.
Trace
Selects the types of traces that are sent to the server.
● None
No traces are sent to the server.
● All
All traces are sent to the server.
● OK
Only OK fastening cycle traces are sent to the server.
● NOK
Only NOK fastening cycle traces are sent to the server.
Save the changes.
8.1.2.7
XML
Under Setup Card Header -> Select Communications Card -> XML
For controller with XML, the plant's IT department must provide these values to allow the SC controller to
communicate on the XML protocol network.
58 / 1032

Publicidad

loading

Este manual también es adecuado para:

Scn