Publicidad
7.4
Networking
The SC controller support the AUDI XML, PFCS, NPL, TOOLSNET, OPEN, Toyota PI (for controllers with serial
ports) and FORD protocols. Ethernet and the Internet Protocol using Transport Control Protocol are a powerful
and robust means of moving data from one computer to another. Many end users rely on it to collect information
from plant floor equipment. For those that haven't switched to this more robust means of collecting data, SC
controllers are available with a serial connection supporting PFCS, OPEN, and Toyota PI Protocols.
7.5
Navigation
The SC controllers have touch screen display on the front of the controller used to facilitate menu navigation,
make selections, and input data.
The SCN controllers do not have any way to navigate or input data from the controller's front panel. These
controllers are programmed using the embedded software called Alpha Toolbox. "See Chapter Configuration
[} 37]" to learn how to use this software.
1
Item
Name
1
Go Back arrow
2
Go Forward arrow
3
Scrollbar
4
Toggle button
2
3
4
6
Description
The symbol for "go back" is typically an arrow pointing to the left.
The Go Forward symbol usually indicates that you can proceed to
the next step or move forward to the next page, screen, or section of
content
It appears on the right side of a window or frame, and it can be
dragged up or down (or left or right) to reveal more of the content
that is currently hidden.
switching between two options (such as on/off, or show/hide) with a
single click
SC Series Controllers
Operation
5
31 / 1032
Publicidad
