Publicidad
SC Series Controllers
Configuration
Outputs
Description
IN CYCLE
Asserts during the fastening cycle when the achieved torque value exceeds the Threshold
Torque value. Resets when the fastening cycle has ended.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
IN REVERSE
Asserts when the tool's operation is set to Reverse. Resets when the tool's operation is set
to Forward.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB COMPLETE
Asserts when a job is completed (accumulated bolt count equals target bolt count). NOTE:
not all bolts may be OK. Resets when a different job is selected or when the input RESET
JOB is asserted.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB OK
Asserts when a job is completed (accumulated bolt count equals target bolt count) and all
bolts are OK. Resets when a different job is selected or when the input RESET JOB is
asserted.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB SELECTED
Asserts when a job is selected by any means. Resets when the active job is complete.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Job: Type the job number that, when selected, asserts this output.
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB SELECTED
Asserts when required to indicate the active job. This is one bit in a series of bits to create
BIT
a binary number. As jobs change so will the binary number created from these bits.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Bit: Type the number this bit to be in the binary number scheme for selected jobs.
Mode: All JOB SELECTED BITs must be the same mode, modes cannot be mixed.
Binary – Creates a decimal number equivalent to the weighted value of this binary bit(s).
Binary + 1 – Creates a number equivalent to the weighted value of this binary bit(s) and
adda the value of one (1) to that number.
72 / 1032
Publicidad
