Publicidad
The step values section provides the torque, angle and current values for each step in the fastening cycle. The
fastening cycle file has only the audit step for each record. If the values for each individual step are required,
this is the place from which to parse the information.
The trace values section provides the captured X and Y axes information to draw the graph.
The events section marks the time at which the events occur, so they can be entered on the graph.
8.3.1.2.4.4
Import
Click the Import button to import a saved trace file for analysis. The file is placed at the top of the fastening cycle
list and be treated as if it were just received from the controller. It will travel down there list as new fastening
cycles are received.
8.3.2
Log
The SC controller stores up to 1000 Events in the log. The B-Series Cordless tools store up to 100 Events in the
log.
The logs display all the events occurred followed by its own respective date and time.
Date:
The date at which the event occurs in the format selected in the Regional tab. The date can be changed by
navigating to Setup->Other->Regional->Clock. The date format can be changed by navigating to Setup->Other-
>Regional-> Date Format.
Time:
The time at which the event occurs in the format HH: MM: SS AM/PM. The time and time zone can be changed
by navigating to Setup->Other->Regional.
8.3.2.1
Event
● Overcurrent Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Logic Voltage Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Position Feedback Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Transducer Span Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Temperature Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Unrecognized Tool- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Tool Communications- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Transducer Current Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Transducer Zero Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Unsupported Tool- "See Chapter Fault Guide [} 118]" for explanation of fault.
SC Series Controllers
Configuration
97 / 1032
Publicidad
