Publicidad
SC Series Controllers
Configuration
Language
Selects the language for the controller screens and files.
Date Format
Selects the Date format for the controller.
24-Hour
Selects the 12 hour or 24 hour clock.
Daylight Saving Time
Modifies the controller time by the appropriate amount.
Time Zone
Selects the time zone for the controller referenced to GMT (Greenwich Mean Time).
Clock
Local Date and Time can be set here. These will be stored with the events and files.
● Time- Sets the controller time.
● Date- Sets the controller date.
Press the SYNC interactive button in Alpha Toolbox to set the controller to the connected computer's date and
time.
Save the changes
8.2
Service area
In this area the user can view information about the tool and controller, reset tool counters, adjust tool
calibration values and upgrade the firmware in the controller and tool.
Users must have TOOL or ADMINISTRATOR access level to modify parameters.
8.2.1
Tool
Under Service Card header -> Select Tool Card
All tool parameters are stored in the tool memory board in the tool's handle. This area reads/writes values to the
tool memory board, not to the controller. Updating the tool's configuration and firmware is managed here.
8.2.1.1
About
Under Service Card header -> Select Tool Card -> About
This tab displays information about the tool currently attached to the controller such as Type, Version, Model,
Serial, Max Torque, Max Speed.
90 / 1032
Publicidad
