Publicidad
The following virtual ports are used for the various protocols of the controller:
Port
Use
80
HTTP
502
ModbusTCP
4545
OPEN
4700
XML
Command
4710
XML Result
6575
Toolsnet
≥10000
PFCS
The SC controller listens on the ports specified but transmits on any available port to the port specified of the
target computer.
5.3.7
Ethernet/IP or Profinet connectors
Ethernet/IP or Profinet Ports are present on SC3 to SC6 series controllers only when the option is installed.
Ethernet/IP or Profinet configured SC controllers have two RJ-45 Ethernet connections located on the bottom of
the controller for connecting to an Ethernet/IP or Profinet network when the option is ordered. The two ports are
connected internally and have the same IP Address. Two ports are provided so that controllers may be daisy-
chained together to create the fieldbus network rather than sending a cable from each controller back to a
switch.
ETHERNET
Listen/Transmit Internet Protocol
Listen/transmit
TCP/IP
Listen/transmit
TCP/IP
Listen/transmit
TCP/IP
Listen
TCP/IP
Transmit
TCP/IP
Listen/Transmit
TCP/IP
Listen/Transmit
TCP/IP
SPINDLE
Browser access to the embedded web server
for configuration and analysis; browser can use
port proxy.
ModbusTCP I/O traffic
OPEN protocol traffic; port is assignable by end
user
XML commands to controller; port is assignable
by end user
XML response from controller; port is
assignable by end user
Toolsnet protocol traffic; port is assignable by
end user
PFCS messaging traffic in Chrysler facilities
SC Series Controllers
Product overview
Description
23 / 1032
Publicidad
