Fig. 9:
Coil raised, in the diagram shown with a tool for removal.
3.5.2 Selecting heating parameters
Automatic modes (SL, N, V, SC):
X Use the + or – button to select the shrink-fit diameter (3–32 mm).
Manual mode (MAN):
X Use the + or – button to select the heating power (0 %–100 %).
3.5.3 Heating process
Gloves
Note: During both shrink fitting and removal, the tool is generally free to be inserted or
removed before the set time has elapsed. This is because the parameters are set to cater
for the most unfavourable combinations of tolerances of the tool and chuck.
If a tool is free to be inserted or removed more quickly, it is best to cancel the heating cycle by pressing
the START/STOP button, so as not to inject more energy than is necessary into the chuck and the tool.
That will also achieve a noticeable reduction in the cooling down time.
X Manually move the coil down over the chuck until
➊
➋
Risk of burns!
Because of the temperatures necessary for shrink-fitting, always wear safety
gloves. When grasping chucks, grip them only at the collar, not at the heated
zone; and always wear gloves! Even when wearing safety gloves, do not exceed
the maximum gripping time of 5 seconds for the heated object!
www.hoffmann-group.com
the lower edge of the coil screening plate rests on
the chuck.
X For shrinking in, place the tool
Hold the tool with two fingers ➋, even during the
heating cycle that now follows, and thereby support
the shrink fitting process.
X For removal of the tool, hold it with two fingers,
even during the heating cycle that now follows,
and support the removal by pulling gently.
Fig. 10:
During the shrink fitting process, hold the
tool wearing a glove.
➊
in position.
DE
EN
FR
IT
ES
CZ
PL
RU
ZH
41