Safety Information For Operating Staff - Nussbaum WA 950 Instrucciones De Uso

2. Safety instructions
Please observe the following safety instructions, for your own
safety and that of your customers.
The safety instructions not only draw your attention to possible
hazards but also provide information as to how you can avoid
them in the first place.
The safety instructions are also incorporated into the operating
instructions, where they are identified by the following symbols:
i
Information - provides information
! ! ! ! !
Caution - draws attention to dangers for test unit/test
piece
Danger for persons - generally marked
or specifically marked
electrocution, risk of injury, risk of burning etc.
60
2.1

Safety information for operating staff

i
To ascertain the sensors are not damaged
!
Drive slowly onto the alignment lift. Pull the hand-brake, do
not put into any gear (in case of automatic drive, set to „N").
Protect the car against rolling away.
! Bevore leaving the lift, be sure the sensors and wheel
clamps are not mounted anymore.
i
WA 920 / 020 only: Switch off the sensors if not in use. Put
them into the charging stations on the trolley.
i
When the wheel alignment system is not in use, switch the
power supply off at the red/yellow main switch.
i Do not leave a vehicle parked on the lift.
No repairs or other work may be carried out on a
vehicle except for wheel alignment at adjustment.
Observe accident prevention regulations.
Before beginning any maintenance work (e.g. repla-
cing bulbs or fuses), disconnect the system from the
electricity supply.
Work on the electrical parts of the system should only
be carried out by a qualified electrician.
Danger of electric shock!
Electrical parts of the system must be protected from
dampness and all other forms of moisture.
Danger of electric shock!
19.03.2010 1 689 979 873N