Front Axle Values For Adjustment; Steering Angle Procedure (For Outgoing Measurement After Adjustment) - Nussbaum WA 950 Instrucciones De Uso

5.14

Front Axle values for adjustment

After you had a look / adjusted on the rear axle values click
Front axle
Will show you the values of front axle only. When you adjust, the
values will change live.
In set-up (Front Axle Adjustment) you can chose, which values
(besides half-toe and camber) shall be shown: either caster or
Total Toe / Symmetry Error.
When clicking on Front axle, you can change to the other
values.
Adjustment with vehicle raised: when you need to lift
the vehicle to do the adjustment, you can „freeze" the
measured values, then lift the vehicle and
unfreeze the values. You then can adjust until your value
is green. Then click
unfreeze the values. The values then should still be
green (maybe you have to repeat).
5.15 Steering Angle Procedure (for outgoing measure-
ment after adjustment)
After you had a look on the front axle values click
Same procedure as 5.9.
1 689 979 873N 19.03.2010
.
1312 9987E
, lower the vehicle and
.
5.16 Front Axle Values (after adjustment)
Will show you same screen as in Front Axis to check, if all values
are still green (o.k.) after steering angle procedure. If not, you now
have the possibility to adjust, because exactly these values will be
printed on the job report.
5.17 Print screen
After you had a look / adjusted on the front axle values click
.
Printscreen
Will show you all results of previous (incoming) values and final
(outgoing) values to proof to the customer what has bee adjusted.
Before you can save on your local databank
Save and print you have to fill in the job record.
Fill in Job Record (also see movie „Fill_Job_Record.avi" on
software CD)
The record can be filled before starting a wheel align-
ment procedure (a job) or after.
1300 9340E
73