Nussbaum WA 950 Instrucciones De Uso página 66

Sensors
A) Handle of the sensor simultaneously serves as the brake lock.
B) Releasing the sensor before removal at the support.
C) Connector for connecting to the central unit or to the other
sensor; can be used in any way desired.
D) Connector for connecting the electronic turntables (only
front sensors).
E) Battery compartment (only for the sensors in the wireless
version WA 920 / 020).
F) Installation help: The arrow indicates the driving direction of
the vehicle.
G) Operating panel with various displays.
Sensor WA 920
Sensor operating panel
A) On/Off for the sensor (only in case of wireless sensor WA
920 / 020).
LED sensor status.
- If the light Sensor in operation comes on continuously
- WA 920 / 020 only: it indicates by blinking, that the
battery has almost draine.
B) Button for executing the run out compensation.
C) Toggle switch measurement operation and compensation
D) LEDs of the electronic level indicator for displaying the
correct sensor leveling
E) LEDs of the electronic level indicator for displaying incorrect
sensor leveling
F) LED sensor connection.
- by going off, it indicates faults at the sensor
- iIf it is lit continuously, the sensor is capable of functioning,
because communications with the central unit are inter
rupted
- if it is blinking, the sensor is capable of functioning and in
communication with the central unit.
G) LED lights up, when, during the run out compensation, the
upper compensation ends and the measured values have
been accepted.
H) LED lights up, when, during the run out compensation, the
lower compensation ends and the measured values have
been accepted.
1 689 979 873N 19.03.2010
K) LED 1 lights up during measurement operation and blinks
during the calibration.
LED 2 lights up in compensation mode and blinks during
calibration.
A)
K)
Operating panel of the WA 920 / 020 sensor
Clamp, manual 1 987 009 A08N
1300 0530
Clamp, manual 1 987 009 A08N
A) The support is fixed to the tire or removed from it by means
of the turning handles.
B) A spoiler adapter 1 987 009 A03N can be mounted on the
support; it is available as an accessory. As a consequence,
the sensor can be displaced downwards, so that the measu-
rements on vehicles are not hindered by low-lying spoilers.
Tighten the sensor on support B) by means of the locking
screw.
C) With the accompanying clamp holder, the setting is made to
the three rim supports for which setting is to be done
individually.
G) E)
B)
B)
C) H) F)
D)
1300 0540
1300 0550
63