Rear Axle Values For Adjustment - Nussbaum WA 950 Instrucciones De Uso

Open Menu brings you to:
Modify max. Steering values: only if me-
chanical turntables are used and only
when steering procedure is done at 20°.
If the max. steering values are not measu
red during the steering wheel procedure,
you can now enter the values with the
keyboard. After entering the values you
have to safe
Main Databank: if you selected the wrong car,
from here you can go to the main databank,
chose the right car. All measured values are
kept and you get back to the data summary with
the new specs.
Units of measurement in degrees: depends on
what has been pre-selected in user set-up.
By pressing button you change between gra
des resp. degrees.
Diameter selection: in general the diameter
from the vehicle specs are taken. For chassis
situation it is important to check diameter of
tyre and to adjust it with
Chassis situation: gives you information about
e.g. axle offset, wheelbase difference, side
offset etc.
You can change from grades to
millimeters by clicking . But therefore
wheel diameter has to be checked (see
above).
Steering angle: will bring you to steering angle proce-
dure.
Front axle: will show you the values of front axle only. If
you click front axle button a second time you get the
values of either caster right / left or Total toe / symmetry
error.
Rear axle: will show you the values of rear axle only. If
you click rear axle button a second time you get the
values of either camber right / left or Track difference
/ symmetry error.
72
.
or .
5.13

Rear Axle Values for adjustment

After you had a look on the data summary you click
Rear axle
Depending on the set-up this screen will be shown after clicking
continue in Data Summary Screen.
Will show you the values of rear axle only. When you adjust, the
values will change live.
In set-up you can chose, which values (besides half-toe, total toe
and thrust angle) shall be shown: either camber or Symmetry
Error / Track Difference).
Clicking on Rear axle, you can change to the other
values.
Adjustment with vehicle raised: when you need to lift
the vehicle to do the adjustment, you can „freeze" the
measured values, then lift the vehicle and
the values. You then can adjust until your value is green.
Then click
values. The values then should still be green (maybe
you have to repeat).
, lower the vehicle and unfreeze the
19.03.2010 1 689 979 873N
.
1312 9986E
unfreeze