Publicidad
Idiomas disponibles
Idiomas disponibles
Intended use
Intended use
This device is designed to be used
- as a lawn tractor for mowing lawns in the house
garden and leisure garden,
- with accessories which are approved expressly for
use with this lawn tractor,
- in accordance with the descriptions and safety
information given in these operating instructions
Any other use is classed as an unintended use.
Improper use is not covered by the warranty and
the manufacturer will reject any liability. The user is
liable for injuries to third parties and damage to their
property.
Unauthorised changes to the device exclude liability
of the manufacturer for any resulting damage and/
or injury.
This device is not licensed for use on public roads or
for transporting people.
Identification plate
You will find the identification plate under/in front of
the driver's seat.
Layout (model-dependent)
1 Model number
2 Model name
3 Weight
4 CE mark
5 Manufacturer
6 Device name
7 Power / engine speed (rpm)
8 Serial number
9 Year of manufacture
10 Guaranteed sound level
Safety equipment
Deflector flap A [Q]
Contact with the cutting blade and items
flung out
ÂRisk of injury
¾ Only operate the device with a deflector
flap attached and lowered.
Safety locking system
The safety locking system will only allow the engine
to start when
- The driver is sitting on the seat.
- the cutter deck has been switched off; i.e.: PTO
switch set to "O/Aus/Off" (PTO = Power-Take-Off).
- the parking brake is applied (park position).
Dependent on the version, the safety locking system
automatically switches the cutter deck (PTO) or
engine off as soon as the operator leaves the seat
with the cutter deck (PTO) activated, irrespective of
whether the parking brake was previously actuated.
The safety locking system automatically switches
the engine off as soon as the operator leaves the
seat without actuating the parking brake beforehand.
In devices without an OCR function or with a
deactivated OCR function, the safety locking
system prevents reversing with the cutting
mechanism activated (automatic shutdown of the
cutting mechanism).
Prior to reversing, switch off the cutting mechanism
using the PTO switch.
Note on the PTO switch
In the case of automatic shutdown through
the safety locking system (e.g. reversing or
leaving the seat with the cutting mechanism
activated), first switch the switch off, and
then back on again, to release the clutch
lock (PTO).
Directional references
Directional references on the device (e.g. left, right,
etc.) always refer to when facing forwards.
Assembly
Note
To be able to move the device manually, the
gear release lever must be in the appropri-
ate position. Refer to the section "Operation
– Pushing the device".
CAUTION!
EN
13
Publicidad
