Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Display cluster H (depending on the model,
optional)
Note
The indicators only come on when the en-
gine is running of if the ignition key is turned
from the STOP position.
Note
If the ignition switch is outside the STOP
position, the egg timer symbol of the display
cluster comes on/flashes to indicate that the
tractor operating hours are being recorded,
irrespective of whether the engine has been
started or not.
Note
If the oil change and air filter maintenance
occur at the same time, the oil change
indicator appears first and then the air filter
indicator.
Dependent on the model, the following indications
appear on the LCD display of the display cluster:
Operating hours/battery voltage indication
When the ignition is switched on, the battery voltage
indicator is displayed for a short period, which
then changes to the operating hours indicator. The
operating hours are displayed in 1/10 hours.
The operating hours are always counted except
for when the ignition key is in the "Stop" position or
when it is removed.
Maintenance indicators
Note
means: The total operating hours are
displayed.
–
–
–
Change the engine oil immediately (see engine
Î
operating instructions).
This indicator appears every 50 operating hours for
a period of 7 minutes.
–
–
The engine oil level is too low.
This indication is only displayed for devices whose
engine has an oil pressure switch.
Switch the engine off immediately and check the
Î
engine oil level (see the engine operating instruc-
tions). Top up the oil if required.
20
If you turn the ignition key to the
battery voltage is briefly shown and then the total
operating hours.
Î
Î
Î
This indicator appears every 25 operating hours for
a period of 7 minutes.
Changing the oil
Cleaning the device
Oil level
¾ Do not use high-pressure cleaners for cleaning
Î
Î
Î
–
–
Charge the battery as quickly as possible.
It may be necessary to have the charging system
checked by a service centre for possible damage.
–
–
–
Perform air filter maintenance immediately (see
engine operating instructions).
Servicing
WARNING!
Risk of injuries or material damage
¾ Only perform maintenance and cleaning work
on the device with the engine at a standstill.
¾ Remove the ignition key and the spark-
plug connectors.
¾ Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾ Never reach into the rotating cutter blades.
¾ Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾ Only have the cutter blades replaced or re-
sharpened by a specialist service centre.
¾ Clean the device and all add-on and
accessory parts after every instance
of use. Collections of very dry dirt and
mowing residues can present a risk of fire.
Attention!
the device.
Park the device on firm and level ground.
Switch the parking brake on.
Clean the device with a scrubbing brush, hand
brush or a cloth.
Note
Also always clean below the device, e.g. in
the area around the rear axle/gearbox and
gearbox fan.
Servicing
Battery voltage
position, the
Air filter mainte-
nance
Publicidad
