Cub Cadet K21 Manual De Instrucciones página 21

Servicing
Cleaning the cutter deck
Sharp, moving cutting tools
ÂRisk of injury
¾ Wear protective gloves.
¾ Caution when cleaning the cutters.
¾ Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
Attention!
Fuel may run into the combustion chamber.
ÂDamage to engine
¾ The device must not be tilted to an angle greater
than 30°.
Clean the cutting chamber with a scrubbing brush,
Î
hand brush or a cloth.
Clean the cutter deck top side, and also below
Î
the V-belt cover/blade spindle cover with a brush,
hand brush or a cloth.
Cutter deck with cleaning nozzle
(optional) N
Cleaning
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
Î
pling to attach a water hose.
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
Î
minutes.
Switch the engine and cutter deck off.
Î
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
Î
deck to run for a few minutes.
Switch the engine and cutter deck off.
Î
Servicing the device
Observe the servicing instructions in the engine
Î
manual.
At the end of the season, have the mower in-
Î
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
DANGER!
Note
Hand over used batteries to your dealer or to
a waste management company. Remove the
battery before scrapping the mower.
Using jump leads
Risk of explosion / short-circuit
¾ Never bypass a defective or frozen
battery with jump leads.
¾ Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive terminal
Î
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Connect the black jump lead first to the negative
Î
terminal (–) of the donor battery.
Connect the other clip to the frame of the engine
Î
block of the device as far away from the battery as
possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Switch the parking brake on.
Î
Start the device.
Î
Disconnect the jump leads in reverse sequence.
Î
Use of the optional multifunction tool Q
(model-dependent)
The multifunction tool is located on the front side of
the right console. It has a 1/2 inch spanner and can
thus be used for loosening and tightening of various
(1/2 inch) screws and nuts.
Tyre pressure
Increased tyre pressure
ÂRisk of accident and damage to the
device.
¾ Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where
Î
necessary.
Recommended tyre pressure:
Front 1.0 bar
Rear 0.65 bar
DANGER!
WARNING!
EN
21