Hilti POS 15 Manual De Instrucciones página 47

en
After the name for the station point has been entered, the corresponding coordinates or positions are searched for in
the graphics data in memory.
If no point data exists under the given name the coordinates have to be entered manually.
10.2.4.2 Entering the target point
A designation that identifies the target point clearly and uniquely must be entered. The coordinates of its position must
belong to this designation.
The target point must exist as a saved point in the job or, alternatively, the coordinates have to be entered manually.
NOTE
When the name for the orientation point is entered, the corresponding coordinates or position are searched for in the
graphics data saved in memory. If no point data exists under this name the coordinates have to be entered manually.
Optional check of distance between the station and the orientation point
After the target point has been entered, this point must be sighted exactly for the purpose of a reference measurement.
After measuring the distance to the orientation point, you have the option of checking the distance between the station
and the orientation point.
This serves as an aid for checking correct point selection and correct sighting of this point, and shows how well the
measured distance corresponds to the distance measured from the coordinates.
42
Enter station names.
Return to previous view.
Confirm entry of station data and
continue with orientation.
Enter the name of the orientation
point.
Return to previous view.
Check distance between the sta-
tion and orientation point.
Continue to "Set station".
Measure angle and distance.