Setting A Station With Coordinates (Height Option "On") - Hilti POS 15 Manual De Instrucciones

After the station has been set, the user can continue with the actual main application previously selected.

10.3.2 Setting a station with coordinates (height option "on")

Defining a new station height
The station height can be determined in three different ways:
en
Direct manual entry of the station height
The station height is determined by manually entering the height of a height mark and by measuring the vertical
angle and distance.
Definition of the station height by selecting a point with heights from data memory and measurement of the
vertical angle and distance to this point
1st Direct manual entry of the station height
After the option for redefinition of the station height has been selected from the previous screen, the new station height
can be entered manually here.
2nd Definition of the station height by entering a height and measuring the vertical angle and distance
The station height is transferred "back" to the station from the height mark, so to speak, by entering the reference
height, tool height and reflector height in conjunction with a vertical angle and distance measurement.
When doing this it is essential that the correct tool height and reflector height are entered.
48
Return to previous view.
Determine new station height
with saved point.
Enter station height manually or
measure to a height mark.
Confirm and apply the entry.
Cancel and return to previous
screen.
Setting the station.