Explanation Of The Pictograms And Other Information; Description; Use Of The Product As Directed; Description Of The Tool - Hilti POS 15 Manual De Instrucciones

1.2 Explanation of the pictograms and other
information
Symbols
Read the General
operating warning
instructions
before use.
Do not turn
the screw
Symbol for Laser Class II / Class 2
Laser class II Laser class 2
according to according to
CFR 21, § 1040 EN 60825:2008
(FDA)
Symbol for Laser Class III / Class 3
Laser class II Do not look
according to into the
CFR 21, § 1040 (FDA) beam with
the naked
eye or with
instruments.

2 Description

2.1 Use of the product as directed

The tool is designed for measuring distances and direc-
tions, calculating target positions in 3 dimensions and
the values derived from these positions and for laying
out points using given coordinates or values relative to a
control line.
To avoid the risk of injury, use only genuine Hilti ac-
cessories and insert tools.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
Take the influences of the surrounding area into account.
Do not use the appliance where there is a risk of fire or
explosion.
Modification of the tool is not permissible.
>1/4s
Return waste Do not look
material for into the
recycling. beam.
3R
optical
Laser exit aperture
Laser exit aperture
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:

2.2 Description of the tool

The POS 15/18 total station can be used to determine the
exact position of objects or points. The tool is equipped
with horizontal and vertical circles with digital graduation,
two electronic levels (compensators), a coaxial laser dis-
tancer incorporated in the telescope and an electronic
processor system for calculating and saving data.
Hilti PROFIS Layout, a PC application provided by Hilti,
can be used to transfer data in both directions between
the total station and a PC, for data processing and for
exporting data to other systems.
en
5