Area Measurement; The Principle Of Area Measurement - Hilti POS 15 Manual De Instrucciones

After selecting the application the list of projects is displayed.
The station does not have to be set for this application.
Measurements to the 1st reference point
The angle and distance are measured to the 1st reference point.
The distance can be measured directly to the point or using the reflector rod, depending on ease of access to the 1st
en
reference point.
Measuring to other points
The other points are always determined by taking angle and distance measurements.
After the second and each further measurement, the correction values compared to the 1st reference point are
updated in the display below.

11.7 Area measurement

11.7.1 The principle of area measurement

The tool can calculate the horizontal or vertical area enclosed by a total of up to 99 consecutively measured points.
The points can be measured in a clockwise or counterclockwise sequence.
74
Return to project selection.
Measure angle and distance to
the 1st. reference point.
Continue to the next measure-
ment.
Return to "Measuring to the first
reference point".
Save results.
Measure angle and distance and
update correction values in the
display.