Setting Up Over A Pipe Using The Laser Plummet; Theodolite Application - Hilti POS 15 Manual De Instrucciones

en
9. Once the electronic "bubble levels" have been centered, check that the laser plummet is aligned exactly with the
mark on the ground and shift the position of the tool laterally on the tripod plate if necessary.
10. Start the tool.
NOTE The OK button becomes active when the level bubbles for line (L) and offset (O) are within a total inclination
of 45".

7.7.3 Setting up over a pipe using the laser plummet

Pipes are often used to mark points on the ground.
In this case, the laser beam is projected into the pipe and the point cannot be seen.
Lay a piece of paper, plastic foil or other semi-translucent material on the pipe in order to make the laser point visible.

7.8 Theodolite application

The theodolite application provides the basic theodolite functions for setting the horizontal circle for taking readings.
24
Increase laser plummet intensity
(settings 1–4).
Reduce laser plummet intensity
(settings 1–4).
Confirms leveling.
Laser plummet indicator symbol.
The heavier the line, the more
intense the laser plummet lights.
Electronic "bubble level" indic-
ator. Center the bubbles.