13.2.1 Fixed points (control points or layout points)
After selecting the applicable job, the option "Points" can be selected in order to enter points with coordinates or to
edit or delete existing points with coordinates.
13.2.1.1 Entering points with coordinates
Manual entry of the point name and coordinates.
If the point name already exists the corresponding warning is displayed, requesting the user to change the point name.
NOTE
The button for the function currently in use is shown in gray.
13.2.1.2 Selecting points from a list or graphical representation
A selection of points from a list and graphical representation is shown below.
Return to previous view.
Select a point from a plan.
Select a point from a list.
Enter a point manually.
Confirm and apply the entry.
Cancel and return to previous
screen.
Select a point from a plan.
Select a point from a list.
Select a point by manual entry.
Confirm and apply the entry.
en
83