Measure And Record; The Principle Of "Measure And Record; Measure And Record With Building Control Lines - Hilti POS 15 Manual De Instrucciones

The results shown
en

11.5 Measure and record

11.5.1 The principle of "Measure and record"

"Measure and record" can be used to measure points with an unknown position.
Distances can be measured with the laser when the laser beam can be aimed directly at a surface.
Depending on the station setup, the positions of points are calculated with building control line dimensions or with
coordinates and/or heights.
The points measured can be assigned various point designations and saved in memory.
NOTE
Each time a point is saved, the number assigned to the name of the point is raised by "1".
The point data saved in memory can be transferred to a PC for further use in a CAD or similar system or printed out
for documentation and archival purposes.
The "Measure and record" application can be started by way of the corresponding button in the application menu.
After starting the application, the projects or list of projects is shown for selection as well as the corresponding station
selection or station setup.
The "Measure and record" application begins after station setup is completed.
Depending on the station setup selected, there are two alternative methods for determining the point system:
1. Point positions that depend on a building control line
2. Point positions that depend on a coordinate system

11.5.2 Measure and record with building control lines

The positions of the measured points relate to the building control line used as a reference.
The positions are described with a line distance on the building control line and a perpendicular offset distance.
70
Return to previous view.
Save results.
Alternative for new line. Continue
to entry of a new 1st. reference
point.
Alternative for next point: Calcu-
late missing line relative to 1st
reference point
Return to previous view.
Continue to "Select further ap-
plications".
Select the "Measure and record"
application.