Entering The Station Position - Hilti POS 15 Manual De Instrucciones

en
Setting up the tool over a point on a building control line
The tool is set up over a point marked on the building control line, from which the points or items to be measured are
easily visible.
Special care must be taken to ensure that the tripod stands steadily and securely.
The position of the tool P0 and the orientation point P1 lie on a common building control line.

10.2.2.1 Entering the station position

A unique designation that clearly identifies the station or tool position must be entered as a unique designation is
necessary for saving the station data.
36
Cancel and return to previous
screen.
Confirm selection and continue
to station identification.
Enter station names.
Return to previous view.
Confirm entry of station data and
continue with orientation.