Setting A Station "Anywhere", With Coordinates - Hilti POS 15 Manual De Instrucciones

The dHD value shown is the difference between the measured distance and the distance calculated from the
coordinates.
Further points can be checked by pressing the "Next" button. In addition to the dHD, the dHA value (which is the
difference between the measured horizontal angle and the horizontal angle calculated from the coordinates) is also
shown in the display.
10.2.4.3 Set station
The station is always saved in internal memory.
If the station name already exists in memory, the station must be renamed. i.e. a new name assigned to it.

10.2.5 Setting a station "anywhere", with coordinates

Setting the station "anywhere" allows the position of the station to be defined by measuring the angles and distances
to two reference points.
The ability to set the station "anywhere" is used when it is not possible to set it at a point on the building control line
or when the line of sight to the points to be measured is obstructed.
Extra care must be taken when setting the station "anywhere".
Additional measurements are taken in order to set the station "anywhere". Additional measurements always present a
risk of errors.
Care must also be taken to ensure that the geometry of the situation allows a usable position to be achieved.
The tool checks the basic geometric relationships in order to ensure that a usable position can be calculated and
issues a warning in critical situations.
Nevertheless, the user of the tool is obliged to exercise special caution in this respect as the software is not capable
of recognizing all potentially critical situations.
Return to previous view.
Continue to the next screen
where further settings can be
made.
For entering station names.
Return to orientation measure-
ment.
Show station data.
Setting the station.
en
43