Hilti POS 15 Manual De Instrucciones página 61

After each distance measurement the tool indicates the amount by which the reflector bearer must move towards the
point to be laid out.
Layout results with coordinates
Shows the layout difference in terms of coordinates based on the last distance and angle measurements.
en
P0 is the position of the tool after setting up.
When measurements are taken to a reflector position not exactly in the direction of the new point, the corresponding
Fwd, Back, Left, Right directions to the new point P1 are displayed.
Saving data for staking out with coordinates
Pt ID
Northings (entered)
Height (entered)
Eastings (entered)
Northings (measured)
Height (measured)
Eastings (measured)
dN
56
Return to entry of layout values.
Save the layout values and last
differences.
Enter the next point.
Name of layout point.
The northings entered refer to the coordinate reference
system.
Height entered.
The eastings entered refer to the coordinate reference
system.
Measured northings refer to the coordinate reference
system.
Measured height.
Measured eastings refer to the coordinate reference
system.
Difference in northing based on the coordinate refer-
ence system. dN = delta north (measured) – delta north
(entered)