Setting A Station "Anywhere", With Building Control Lines - Hilti POS 15 Manual De Instrucciones

en
Rotating the axis
The axis bearing (direction) can be rotated about the starting point. If the value entered is positive, the axis is rotated
clockwise. If it is negative, the axis is rotated counterclockwise.
After the station has been set, the user can continue with the actual main application previously selected.

10.2.3 Setting a station "anywhere", with building control lines

Setting the station "anywhere" allows the position of the station to be defined by measuring the angles and distances
to two reference points.
The ability to set the station "anywhere" is used when it is not possible to set it at a point on the building control line
or when the line of sight to the points to be measured is obstructed.
Extra care must be taken when setting the station "anywhere".
Additional measurements are taken in order to set the station "anywhere". Additional measurements always present a
risk of errors.
Care must also be taken to ensure that the geometry of the situation allows a usable position to be achieved.
The tool checks the basic geometric relationships in order to ensure that a usable position can be calculated and
issues a warning in critical situations.
Nevertheless, the user of the tool is obliged to exercise special caution in this respect as the software is not capable
of recognizing all potentially critical situations.
38
Return to previous view.
Enter axis shift manually.
Take measurement to point. The
axis, distance and height values
are shown. The values can be
individually labeled.
Rotate axis.
Continue to the next step.
Return to previous view.
Confirm rotation.