Applications; Horizontal Layout (Horz. Layout); The Horizontal Layout Principle - Hilti POS 15 Manual De Instrucciones

Showing the recalculated station height after measurement
The recalculated station height is shown after taking the angle and distance measurements and it can then be
confirmed or canceled.
en
Set station
If the "With heights" option has been selected, the station heights will be shown in the "Set station" screen.
These can be confirmed or redefined.
NOTE
When the "Heights" option is active, a height must be assigned to the station, i.e. a height value must exist. If no
station height is given, an error message is displayed and the user is instructed to determine the station height.

11 Applications

11.1 Horizontal layout (Horz. layout)

11.1.1 The horizontal layout principle

The layout operation is used to transfer data from the plan to the actual object or building plot.
This plan data consists either of dimensions that relate to building control lines or positions described by coordinates.
The plan data or layout positions can be entered as dimensions or distances, as coordinates or can be transferred
previously from a PC.
In addition, plan data in the form of CAD drawings can be transferred to the total station and the applicable graphical
points for the layout then selected from the display of the tool.
This makes working with long numbers or lots of numbers unnecessary.
50
Cancel and return to previous
screen.
Setting the station.
Return to orientation measure-
ment.
Enter station height or height
mark manually or, respectively,
select a previously saved height
point with measurement of ver-
tical angle and distance.
Show station data.
Setting the station.