Vertical Layout With Building Control Lines - Hilti POS 15 Manual De Instrucciones

en
After starting the application, the projects or list of projects is shown for selection as well as the corresponding station
selection or station setup.
The "Vertical layout" application begins after station setup is completed.
Depending on the station selected, there are two alternative methods for determining the point to be laid out:
1. Laying out points with building control lines, i.e. control lines in the vertical reference plane.
2. Laying out points with coordinates or points based on a CAD drawing

11.2.2 Vertical layout with building control lines

In a vertical layout with building control lines the control lines are defined by measuring to two reference points when
the station is set up.
Setting up the station
The station should be set up in front of the vertical plane in a position that is as central as possible and at a distance
that allows as clear a view as possible of all points.
The zero point (1) of the reference axis system and the direction (2) of the vertical reference plane are defined when
the tool is set up.
Caution
The reference point (1) is the decisive point. The vertical and horizontal reference axes in the vertical reference plane
are set on this point.
An optimum setup or, respectively, tool position has been achieved when the ratio between the horizontal reference
length L and the distance Q is L : Q = 25 : 10 to 7 : 10, so that the included angle lies between α = 40° - 100°.
58
Return to previous view.
Continue to "Select further ap-
plications".
Select the "Vertical layout" ap-
plication.