Setting A Station Over A Point With Control Lines - Hilti POS 15 Manual De Instrucciones

4 alternative ways of setting the station
NOTE
The "Set station" process always includes setting a position and an orientation.
When one of the four applications is started, such as Horizontal Layout, Vertical Layout, As-Built or Measure and
Record, a station and orientation always have to be set.
If, in addition, heights are also to be used, i.e. target heights are to be determined or laid out, the height of the center
of the telescope must also be defined.
Summary of alternatives for setting the station (6 options)
Heights
Point system
Setup location

10.2.2 Setting a station over a point with control lines

The dimensions or position description of many parts of a structure are given in relation to a building control line on
the plan.
With the total station, building control lines and their corresponding dimensions can also be used.
Cancel and return to previous
screen.
Confirm selection and continue
to station identification.
On, off
This setting determines whether heights are to be cal-
culated or shown.
Building control line
Manually enter data that refers to the building control
line (along the line or offset).
Coord / Graph
Use coordinates or graphic data from the plan / CAD.
Over Pt
The tool station is located over a point with a marked
and known position.
"Anywhere"
The tool station can be set "anywhere". The position of
the station must be measured or calculated from meas-
urement data.
en
35