Hilti POS 15 Manual De Instrucciones página 67

Entering the layout values (from a CAD drawing)
With this method the layout points are selected directly from CAD graphics.
With this method, the point is already incorporated in the drawing as a three-dimensional or two-dimensional point
and can be extracted accordingly.
en
Layout results with coordinates
Shows the layout difference in terms of coordinates based on the last distance and angle measurements.
Saving data for staking out with coordinates
Pt ID
Northings (entered)
Height (entered)
Eastings (entered)
Northings (measured)
Height (measured)
Eastings (measured)
dN
62
Shows the point selected from
the graphical display.
Return to entry of layout values.
Select a point from a plan.
Select a point from a list.
Enter coordinates manually.
Confirm the selected point.
Return to entry of layout values.
Save the layout values and last
differences.
Enter the next point.
Name of layout point.
The northings entered refer to the coordinate reference
system.
Height entered.
The eastings entered refer to the coordinate reference
system.
Measured northings refer to the coordinate reference
system.
Measured height.
Measured eastings refer to the coordinate reference
system.
Difference in northing based on the coordinate refer-
ence system. dN = delta north (measured) – delta north
(entered)