LaCimbali M40 Manual De Uso Y Mantenimiento página 47

WARNING: Do not release the portafilter from
the appliance before the coffee dispensing has
ended.
94.0°C
• The pre-infusion phase begins (shown on the display
by icon 1 - Tab. 5.1).
• At the end of the infusion phase, dispensing begins
(shown on the display by icon 2 - Tab. 5.1).
• When the set dose has been reached, dispensing
stops automatically.
• Before returning to standby, the display shows the dis-
pensing parameters for a few seconds: total dispens-
ing duration and infusion phase duration.
• Continuous dispensing can be obtained by pressing
the button.
• Dispensing, both dosed (
continuous ( ), can be interrupted by pressing the
button or any other dose dispensing button (
/ / / ).
NB: The button can be programmed as
"dosed".
6.3
• Place a suitably sized container underneath the hot
• Press the hot water dose button corresponding to the
• When the set dose has been reached, dispensing
• Dispensing can be interrupted by pressing the previ-
6.4
/ / / ) and
HOT WATER DISPENSING
WARNING: Risk of scalding; use the relative
insulating devices when handling the water
and steam wands.
NB: If the appliance has remained unused for
more than 1 hour, run a no-load dispensing of
about 200 ml before activating a proper dis-
pensing.
water dispenser (6 - Fig. 4.1).
required dose ( / /
stops automatically.
ously selected button again.
STEAM DELIVERY
WARNING: Risk of scalding; use the relative
insulating devices when handling the water
and steam wands.
WARNING: Always clean the steam wand after
using it (see par.8.5.1).
NB: Before using the steam wand, let steam
out of it for at least 3 seconds to ensure the
condensation is released.
NB: After 8 hours of non-use, point the wand
towards the cup-holder tray and release steam
for at least 1 minute.
/).
47
EN