LaCimbali M40 Manual De Uso Y Mantenimiento página 66

EN
10.1 STATUS INDICATIONS
INDICATION
Machine cold.
Wait
Carry out
maintenance
Carry out resin
regeneration
Filter replacement
Machine OFF
Energy saving
mode
Messages relating to washing
66
CAUSE
A dispensing button is pressed, but the water
heater has not reached the set operating pressure.
The machine requires a maintenance intervention.
To temporarily cancel the indication, go to the
programming menu and press the icon of the
relative intervention (see Tab. 8.3). The message
will reappear the next time the machine is
switched on.
The appliance requests a resin regeneration
intervention. Refer to the specific water softener
documentation.
The appliance requests the replacement of the
water filter. To temporarily cancel the indication, go
to the programming menu and press the icon of
the intervention (see Tab. 8.3). The message will
reappear at regular intervals.
The appliance is in standby mode.
The appliance is in energy saving mode.
SOLUTION
Wait for the water heater to reach the
operating pressure.
To carry out appliance maintenance,
contact the technical support service.
Carry out the resin regeneration.
To remove the message, go to the
programming menu and press the icon of
the intervention (see Tab. 8.2) .
To replace the water filter, contact the
technical support service.
Press any dispensing button to quit
standby mode and force the appliance
ON.
Press any dispensing button to quit
energy saving mode and return to the
working phase.
Refer to par.8.2.