LaCimbali M40 Manual De Uso Y Mantenimiento página 51

• Steam: number of delivery operations of the single
steam buttons of the turbosteam selector (1, 2, 3,
4 - Fig. 5.3)
The counter values can be zeroed using the Reset button.
7.1.6 PROGRAMMING THE DOSES (COFFEE)
• Select one of the coffee groups (e.g. group3).
• The display of the selected dispensing group will show
the numbers corresponding to the buttons.
• Select the dose dispensing button you want to program
(e.g. button 1).
• The icon of the selected button will be highlighted on
the dispensing group display.
• On the services display, program the dispensing for the
selected button:
Fig. 7.8 - Coffee dose programming menu
1. Type: used to select the dose dispensing button
2. Dose: used to set the dispensing seconds
Press the
dose. The test screen will visualise the following param-
eters:
• Vd: incremental count of the volumetric dosers
• Dt: dispensing time
• BT: instantaneous coffee boiler temperature
• BR: % activation of coffee boiler resistor
• P: water heater pressure
• Lev: water level in the water heater; level signal %
• WHr: water heater resistor
• WHsv: water heater filling solenoid valve
• ST: steam temperature (turbosteam wand probe)
7.1.7
• Select the icon corresponding to the water dispensing
group.
• The water buttons can be programmed on the services
display. The parameters that can be set are:
2 1
2 2
Fig. 7.9 - Water dose programming menu
1. Select the water button to be programmed.
2. SET: used to set the dispensing time
Press the
dose.
button to run a dispensing test with the set
PROGRAMMING THE DOSES
(WATER)
button to run a dispensing test with the set
EN
2 1 2 1
2 2
51