Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Operation
NOTE!
Before turning back the rotor, release the torch articulated arm again, and swivel back to
the Home position until it latches in (see chap. 8.5, p. 92).
Either:
Manually:
X Press the friction coupling (1) and turn the welding tongs manually (counter-clockwise) to the Home/0 position.
Using the remote control with motor support (optional):
X Press the key "0-Pos" (3) or "Rotation backwards" (2).
Via the power source:
X Manual control > Rotation > Rotation backwards or Home position.
1
9.4
Aborting welding
Danger of burning at the workpiece and in the welding zone of the welding tongs!
X Read the operating instructions of the welding power source.
X Press the red "START/STOP" key (4) directly at the welding tongs. This stops the running process. Only the programmed gas
post purge time continues to run.
4
102
ORBITALuM TOOLS GmbH D-78224 Singen www.orbitalum.com
ORBIWELD TP 400, TP 600
2
8
9
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
ORBIWELD TP 400, TP 600
X Press the Stop key (5), Softkey 1 (6) or touch screen button (7) on the power source.
7
6
5
X Press the red "STOP" key (9) on the remote control.
X In emergencies press the gray EMERGENCY OFF key (8) on the remote control.
3
9.5
Removing the welding tongs from the workpiece
1. Loosen the clamping lever (10).
2. Remove the welding tongs from the workpiece and put it
down securely.
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
Operation
7
8
9
10
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
ENGLISH
103
Publicidad
