Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Operation
9.6
Preparing storage
Carry out the following steps before storage:
1. Remove the electrode and, if applicable, the cold wire (only for KD versions), see chap. 8.4, p. 92 and, if applicable, chap.
8.6, p. 96.
2. Remove the handle, see chap. 6.3, p. 81.
3. Disconnect the welding tongs from the welding power supply, see chap. 8.2, p. 83.
4. Place the end caps for the cooling liquid over the cooling liquid connections.
5. Store the welding tongs in the transport case. Ensure that the hose package is not twisted or squeezed.
Carry out the following steps additionally before longer storage periods:
6. Remove the cooling liquid completely (by means of compressed air).
7. Clean the surfaces.
Further care and maintenance instructions, see chap. 10, p. 105.
104
ORBITALuM TOOLS GmbH D-78224 Singen www.orbitalum.com
ORBIWELD TP 400, TP 600
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
ORBIWELD TP 400, TP 600
10. MAINTENANCE AND TROuBLESHOOTING
10.1
Instructions for care
X Ensure that no dirt particles or small items enter the transmission (welding tongs inside) (the transmission is open at the
welding tongs end for design reasons).
X If the surfaces are soiled, use only residue-free cleaning agents for cleaning.
10.2
Maintenance and care
The following instructions for care depend, if not stated otherwise, strongly on the usage of the welding tongs.
Shorter cleaning intervals influence the equipment service life positively.
INTERVAL
Before every use
After about every 20th welding seam
At least every 250 welding processes
Regularly (depending on usage)
Weekly
Quarterly
Annually
Every 2 years
[REV. 20231027] OW_ORBIWELD_TP_BA_812060201_01__INH-01_EN
ENGLISH
Maintenance and troubleshooting
ACTIVITY
X Check the hose package and welding tongs for damage.
X Check the electrode.
X Replace or regrind the electrode.
X Carry out the standard cleaning process of the welding tongs
(see chap. 10.2.1, p. 106).
X A shorter cleaning interval can influence the service life of
the welding tongs positively.
X Blow out the welding tongs regularly by means of com-
pressed air.
X Clean the rotor with acetone.
X Remove old grease in the rotor area by washing with a
grease solvent.
X Grease the area of the brass rotor with a suitable lubricant
(such as CASTROL LONGTIME PD 2).
X Grease all further moving parts with suitable lubricants.
X Have the power-cooling liquid cable replaced by the Service
of Orbitalum Tools GmbH.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
105
Publicidad
