Champion Power Equipment 97001i-P-EU Manual Del Operador página 11

97001i-P-EU
Control Panel
2
1
1. Fual Dial – Used to start, stop and choke the generator.
2. Intelligauge – See Intelligauge section.
3. Circuit Breakers (Push Reset) – Protects the generator
against electrical overloads.
4. Ground Terminal – Consult an electrician for local grounding
regulations.
5. Start/Stop Button
RECEPTACLES
12V DC, 8A (Regulated Automotive)
z
A May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
220V AC, 16A
May be used to supply electrical power for
B
operation of 220 Volt AC, 16 Amp, single phase,
50 Hz electrical loads.
ATS PORT
C
Used to transmit control signals with ATS.
220V AC, 32A
May be used to supply electrical power for
D
operation of 220 Volt AC, 32 Amp, single phase,
50 Hz electrical loads.
220V AC, 16A
May be used to supply electrical power for
E
operation of 220 Volt AC, 16 Amp, single phase,
50 Hz electrical loads.
B
A
3
5
E
When charging a device, do not place on the exhaust side of
the generator. Extreme heat caused by exhaust can damage
the device and cause a potential fire hazard. Prolonged
exposure to engine exhaust can cause serious injury or death.
Fual Dial
1
1. Engine Run
2. Fuel Off
3. Engine Stop
11
CONTROLS AND FEATURES
C
D
4
WARNING
A
EN
2
3