Champion Power Equipment 97001i-P-EU Manual Del Operador página 24

97001i-P-EU
4. Insert the ATS connector into the ATS interface between ATS
and generator.(Not Included, ATS Panel and Communication
lead sold Separately)
5. Connect ATS to utility power, the "MAINS" indicator on the
ATS chassis panel will be light.
6. Connect ATS to generator power.
7. Press the AUTO button on the ATS chassis panel, the "AUTO"
indicator will be light.
8. When the utility power go off, the generator will start
automatically.
F A U LT
A U T O
O R
E R A T
G E N
S
M A IN
UA L
M AN
AU TO
A T S
For petrol restarts with hot engine and(or) in hot
ambient temperature >86°F (30°C): Rotate the fuel dial to
the "CHOKE" position for only one pull of the recoil cord. If
generator does not start after first pull, rotate the dial to the
"RUN" position for the next three pulls. Too much choke leads
to spark plug fouling and engine flooding. This will cause the
engine not to start.
For petrol starting in standard ambient temperature
>59°F (15°C): Keep fuel dial in "CHOKE" position for three
pulls of the recoil cord. If generator does not start after three
pulls, rotate the fuel dial to the "RUN" position for the next
three pulls. Too much choke leads to spark plug fouling and
engine flooding. This will cause the engine not to start.
For petrol starting in cold ambient temperature < 59°F
(15°C): Keep the fuel dial in the "CHOKE" position until engine
starts. As soon as the engine starts and runs smoothly turn the
fuel dial to the "RUN" position. In extreme cold temperatures,
this may take several seconds.
If the engine starts but does not continue to run make certain
that the generator is on a flat, level surface. The engine is
equipped with a low oil sensor that will prevent the engine
from running when the oil level falls below a critical threshold.
24
OPERATION
NOTICE

NOTICE

NOTICE

NOTICE
