Descargar Imprimir esta página

Champion Power Equipment 97001i-P-EU Manual Del Operador página 35

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 191
97001i-P-EU
5. Using a flat head screwdriver (not included), rotate drain
screw counterclockwise (3) full turns. Petrol will drain through
clear tubing out underneath the inverter. Make sure draining
petrol empties into an appropriate container.
6. When petrol stops flowing from the clear tube, rotate drain
screw clockwise until tight. Properly dispose of the drained
petrol according to local regulations or guidelines.
7. Turn the fuel dial to the "STOP" position.
8. Follow steps 7-13 according to Short to Mid Term Storage.
Removing from Storage
If the generator has been improperly stored for a period longer
than 30 days with ethanol blended gasoline in the petrol tank
and/or carburetor, all fuel must be drained and the carburetor
must be thoroughly cleaned of ethanol build up. This process
involves technically advanced tasks.
If the fuel tank and carburetor were properly emptied of all
ethanol blended petrol prior to the generator being stored,
follow the below steps when removing from storage.
1. Be sure the fuel dial is in the "STOP" position.
2. Add petrol to the generator according to Add Fuel.
3. Move the fuel dial to the "RUN" position.
4. After 5 minutes check the carburetor and air filter areas for
any leaking petrol. If any leaks are found, the carburetor will
need to be disassembled and cleaned or replaced. If no petrol
leaks are found, turn the fuel dial to the "STOP" position.
5. Check engine oil level and add clean, fresh oil if needed. See
Oil Specifications for proper oil type.
6. Check and clear air filter of any obstructions such as bugs or
cobwebs. If necessary, clean air filter according to Cleaning
the Air Filter.
7. Start the generator according to Starting the Engine.
NOTICE
35
STORAGE
EN

Publicidad

loading