Champion Power Equipment 97001i-P-EU Manual Del Operador página 15

97001i-P-EU
Connect the Battery
1. Place the generator on a flat, level surface.
2. Loosen the four cover screws and remove the maintenance
cover.
3. Push two halves of battery connector together tightly.
Add Engine Oil
WARNING
A
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.

The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
NOTICE
The recommended oil type for typical use is 10W-30
automotive oil. However, using the listed conventional oils
shown in the "Recommended Engine Oil Type" chart may be
used for typical use including the first 5 hours of the break-in
run time period of the engine.
If running generator in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
Recommended Engine Oil Type
5W-30
°F -20 0 20
°C
-28.9 -17.8 -6.7
1. Place the generator on a flat level surface. Do Not angle or tip
the generator when adding oil.
2. Loosen the four cover screws and remove the maintenance
cover.
3. Remove oil fill cap/dipstick to add oil.
15
ASSEMBLY
NOTICE

10W-30
10W-40
5W-30 Full Synthetic
40 60 80 100
4.4 15.6 26.7 37.8
Ambient temperature
120
EN
48.9