Champion Power Equipment 97001i-P-EU Manual Del Operador página 27

97001i-P-EU
WARNING
A
HIGH VOLTAGE
Always isolate the incoming main power supply before opening
and entering the ATS panel. Only qualified electrician should
open and enter this ATS panel.
Operation indicator: showing the electric power state.
Position " I" Incoming main city power
Position "O" Double channel power off,
Position "II" Standby / Auxiliary power
8. ATS Function:
When incoming main city power drops or lost, switch turns to
Standby / Auxiliary power automatically. When incoming main city
power restored, switch returns to incoming main city power .
When both, manual handle in position "O", and switch in position
"O", it will turn off and double isolate all channels.
9. Wiring Drawing
Eco (Economy) Mode
The Eco Mode button can be activated to turn on economy control
in order to minimize fuel consumption and noise while operating
the unit during times of reduced electrical output. Eco Mode
allows the engine speed to idle during periods of non-use.
The engine speed returns to normal when an electrical load is
connected. When the economy switch is off, the engine runs at
normal speed continuously.
For periods of high electrical load or momentary fluctuations,
the Eco Mode should be off.
12V DC Regulated Automotive Style Outlet
The 12V DC outlet(s) can be used with supplied accessories and
other commercially available 12V DC automotive style plugs.
Confirm the input voltage range of your item is at least 12-24V DC.
Do not operate a device while it is plugged into the 12V DC
outlet. When charging a device, do not place near or on the
exhaust side of the generator. Extreme heat caused by exhaust
can damage the device and cause a potential fire hazard.
Prolonged exposure to engine exhaust can cause serious injury
or death.
Battery Charging
1. Before connecting the battery charging cable (not included) to
a battery that is installed in a vehicle, disconnect the vehicle
battery ground cable from the negative (–) battery terminal.
2. Plug the battery charging cable into the 12V DC receptacle of
the generator.
3. Connect the red (+) battery charger lead to the red (+) battery
terminal.
4. Connect the black (–) battery charger lead to the black (–)
battery terminal.
5. Start the generator.
27
OPERATION
CAUTION
A
WARNING
A
EN