Champion Power Equipment 97001i-P-EU Manual Del Operador página 4

97001i-P-EU
A
Spark from removed spark plug wire can result in fire or
electrical shock.
When servicing the generator:
Disconnect the spark plug wire and place it where it cannot
contact the plug or any other metal object.
DO NOT check for spark with the plug removed.
Use only approved spark plug testers.
A
Running engines produce heat. Severe burns can occur on
contact. Combustible material can catch fire on contact.
DO NOT touch hot surfaces like engine or muffler/exhaust,
always allow to cool for minimum 30mins.
Avoid contact with hot exhaust gases and allow to cool min 30
mins.
Allow equipment to cool min 30 mins before touching or
handling.
Maintain at least 3 ft. (91.4 cm) of clearance on all sides to
ensure adequate cooling.
Maintain at least 5 ft. (1.5 m) of clearance from combustible
materials.
A
Rapid retraction of the recoil cord will pull hand and arm
towards the engine faster than you can let go. Broken bones,
fractures, bruises or sprains could result. Unintentional
startup can result in entanglement, traumatic amputation or
laceration.
A
When starting the engine, pull the recoil cord slowly until
resistance is felt, release cord back and use one strong rapid
pull to start, this avoids any kickback or damage to the recoil
assembly. Rigorously pulling will result in damage to the recoil
assembly and void any warranty.
A
Although the generator contains a spark arrester, maintain
a minimum distance of 5 ft. (1.5 m) from dry vegetation to
prevent fires.
WARNING
WARNING
WARNING
CAUTION
WARNING
IMPORTANT SAFETY INSTRUCTIONS
Exceeding the generator's running capacity can damage the
generator and/or electrical devices connected to it.
DO NOT overload the generator.
DO NOT tamper with the governed speed.
DO NOT modify the generator in any way.
Do Not install or modify the exhaust/muffler with any
extension or extraction, by doing so will void any warranty
offered
Start the generator and allow the engine to stabilize before
connecting electrical loads.
Connect electrical equipment in the off position, and then turn
them on for operation.
Turn electrical equipment off and disconnect before stopping
the generator.
Improper treatment or use of the generator can damage it,
shorten its life or void the warranty.
Use the generator only for intended uses.
Operate only on Flat level surfaces.
DO NOT expose generator to excessive moisture, dust,
or dirt.
DO NOT allow any material to block the cooling slots.
If connected devices overheat, turn them off and disconnect
them from the generator.
DO NOT use the generator if:
– Electrical output is lost
– Equipment sparks, smokes or emits flames
– Equipment vibrates excessively
4
CAUTION
A
CAUTION
A
CAUTION
A