Champion Power Equipment 97001i-P-EU Manual Del Operador página 21

97001i-P-EU
6. Push and hold the wireless set button for approximately three
seconds until the blue LED on wireless set button turns off.
7. Follow the remote START and STOP instructions to verify the
remote(s) are working properly.

Only two remote key fobs transmitter can be synchronized to
the generator at one time. If pairing second remote and do not
want to erase programming on current remote, skip step 4.

Changing a remote key fob transmitter battery may not require
the user to reset the remote. If remote does not function
after changing the battery, proceed with Wireless Set Button
instructions.
Surge Protection
Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
– Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They're designed to protect against virtually all short-duration
voltage fluctuations.
NOTICE
NOTICE
Starting the Engine: No ATS or ATS on
Manual Mode
Manual Start
1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never
start or stop the generator manually with electrical devices
plugged in or turned on.
3. Turn the fuel dial to the "ON" position.
4. Press the Start/Stop button to enter standby mode.The button
will flash green but the generator will not attempt to start.
5. Press the "CHOKE" button.
21
OPERATION
EN