Publicidad
Idiomas disponibles
Idiomas disponibles
97001i-P-EU
ASSEMBLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold
each side flat on the ground to provide a surface area to work
with the generator.
Remove Shipping Support Hardware
To protect the generator during shipping, support hardware has
been installed between the engine and frame. This hardware
MUST BE REMOVED BEFORE adding oil or petrol to the generator.
IMPORTANT NOTICE
DO NOT attempt to run generator without first removing the
shipping support hardware. Damage to the generator as a result
of not removing the hardware will void the warranty.
1. BEFORE filling the engine with oil or petrol, tip the generator
onto its side as shown. Tip onto the flattened cardboard box
the generator came in or other protective surface so as to not
scratch the frame.
2. Remove the orange bolts from the bottom panel. Bolts can be
discarded.
Install the Wheel Kit
The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Before adding fuel and oil, ensure the generator is still on its
side from previous step.
2. Slide the roll pin (C) through the wheel (A) from the outside.
3. Slide the roll pin through the mount point on the frame.
4. Insert r-clip (D) into hole at end of roll pin.
5. Install hub cap (B) on wheel.
6. Roll the generator onto the other side and repeat above steps
to attach the second wheel.
Install the Support Leg
1. Attach the support leg (E) to the generator frame with flange
lock bolts (F).
2. Tip the generator upright. Do not leave generator tilted on its
side unattended or for an extended period.
14
ASSEMBLY
CAUTION
A
A
B
C
E
D
F
Publicidad
