Champion Power Equipment 97001i-P-EU Manual Del Operador página 23

97001i-P-EU
Wireless Remote Start
Wireless remote starting is only possible within 80 feet of the
generator.
DO NOT attempt to adjust the choke. The remote system will
automatically close and open the choke.
1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never start
or stop the generator with electrical devices plugged in or
turned on.
3. Turn the fuel dial to the "ON" position.
4. Press the Start/Stop button to enter standby mode. If
generator was turned off using the remote key fob transmitter
within the last 24 hours, it will already be in standby mode.
The button will flash green but the generator will not attempt
to start.
5. Press and release the "START" button on the remote control
transmitter. DO NOT hold the button down, only press the
button once. The engine will attempt to start six times.
If CO Shield detects elevated levels of CO gas resulting in
the generator shutting down, Wireless Remote starting will
become disabled and will not be able to restart the generator.
Move generator to an open, outdoor area and point the
exhaust away from people and buildings. Once relocated to a
safe area, the generator can be restarted by either using the
Electric Start or Manual Start instructions. Once the generator
is restarted, the Wireless Remote starting will be active again
and can be used to START/STOP the generator.
Starting the Engine: ATS on Automatic Mode
1. Make certain the generator is on a flat, level surface.
2. Turn the fuel dial to the "ON" position.
3. Press the Start/Stop button to enter standby mode.The button
will flash green but the generator will not attempt to start.
23
OPERATION
NOTICE

EN