Type Key; Scope Of Delivery; Accessories (Optional/Available On Request); Transport And Storage - Wilo EMU FA Serie Instrucciones De Instalación Y Funcionamiento

English

3.7. Type key

Example: Wilo-EMU FA 10.82E + T 20.1-4/22KEx
Hydraulics definition
FA Waste water series
Nominal diameter of pressure connection,
10
e.g.: DN 100
82 Internal performance figure
Impeller shape
W = free-flow impeller
WR = free-flow impeller with mechanical stir-
ring device
E E = single-channel impeller
Z = double-channel impeller
D = triple-channel impeller
V= quadruple-channel impeller
T = SOLID impeller
Motor definition
T Dry motor
20 Size
1 Model
4 Number of poles
22 Package length in cm
K Seal variation
Ex Motor with explosion approval

3.8. Scope of delivery

Standard items
• Pump with 10 m cable and free cable end
• Installation and operation instructions
Freely configurable items
• Pump with cable length chosen by the customer
• Cable version (dependent on type) with
• free cable end
• plug
• float switch and free cable end
• float switch and plug
• Fitted accessories, e.g. sealing chamber monitor,
pump base, etc.
• Installation and operation instructions

3.9. Accessories (optional/available on request)

• Suspension unit
• Pump base
• External sealing chamber monitor
• Level controllers
• Versions made of cast stainless steel or Abrasite
and with Ceram coating for aggressive or abrasive
fluids
• Thermal motor monitor with PTC sensors
• Various monitoring equipment
• Fixing accessories and chains
• Switching devices, relays and plugs
50

TRANSPORT AND STORAGE

4. Transport and storage

4.1. Delivery

Upon receipt of the delivery, it is to be checked
immediately for damage and completeness. If any
parts are damaged or missing, the transport
company or the manufacturer must be notified
on the day of delivery. Claims made after this date
cannot be recognized. Damage to parts must be
noted on the delivery or freight documentation.

4.2. Transport

Only the appropriate and approved fastening de-
vices, transportation and lifting gear may be used.
These must have sufficient load-bearing capacity
to ensure that the pump can be transported safe-
ly. If chains are used they must be secured against
slipping.
The personnel must be qualified for the tasks and
must follow all applicable national safety regula-
tions during the work.
The pump is delivered by the manufacturer or
shipping agency in suitable packaging. This nor-
mally precludes the possibility of damage occur-
ring during transport and storage. The packaging
should be stored in a safe place for reuse if the
product is frequently used at different locations.

4.3. Storage

Newly supplied pumps are prepared so that they
can be stored for at least 1 year. The pump should
be cleaned thoroughly before it is put into tem-
porary storage.
The following should be taken into consideration
for storage:
• Place the pump on a firm surface and secure it
against slipping and falling over. Wastewater
submersible pumps are stored vertically.
DANGER from falling over!
Never set down the pump unsecured. If the
pump falls over, injury can occur!
• The pumps can be stored at temperatures down
to -15 °C. The store room must be dry. We recom-
mend a frost-proof room for storage with a tem-
perature between 5 °C and 25 °C.
• Any suction or pressure connections should be
closed tightly before storage to prevent contam-
inants.
• The current supply cables should be protected
against kinking, damage, and moisture.
ELECTRICAL hazard!
Damaged power supply cables can cause fatal
injury! Defective cables must be replaced by
a qualified electrician immediately.
BEWARE of moisture!
Moisture penetrating the cable will damage
both the pump and the cable. Never immerse
the cable end in fluid and always protect it
from moisture.
WILO SE 05/2014 v05 DIN A4