Getting Started; Understanding The Display; Sm-Keypad Plus (Lcd); Keypad Operation - Control Techniques UNIDRIVE SP1201 Guía Rápida

Safety Product Mechanical
Information Information Installation
5

Getting Started

This chapter introduces the user interfaces, menu structure and security level of the drive.
5.1

Understanding the display

There are two keypads available for the Unidrive SP. The SM-Keypad has an LED display and the
SM-Keypad Plus has an LCD display. Both keypads can be fitted to the drive but the SM-Keypad
Plus can also be remotely mounted on an enclosure door.
5.1.1 SM-Keypad (LED)
The display consists of two horizontal rows of 7
segment LED displays.
The upper display shows the drive status or the
current menu and parameter number being
viewed.
The lower display shows the parameter value or
the specific trip type.
Figure 5-1 SM-Keypad
Upper display
Lower display

Control buttons

Fwd / Rev (blue) button
Stop/reset (red) button
Start (green) button
NOTE
The red stop
Both the SM-Keypad and the SM-Keypad Plus can indicate when a SMARTCARD
access is taking place or when the second motor map is active (menu 21). These are
indicated on the displays as follows.
SMARTCARD access taking
place
Second motor map active
5.2

Keypad operation

5.2.1 Control buttons
The keypad consists of:
1. Joypad - used to navigate the parameter structure and change parameter values.
2. Mode button - used to change between the display modes – parameter view,
parameter edit, status.
3. Three control buttons - used to control the drive if keypad mode is selected.
4. Help button (SM-Keypad Plus only) - displays text briefly describing the selected
parameter.
The Help button toggles between other display modes and parameter help mode. The
up and down functions on the joypad scroll the help text to allow the whole string to be
Unidrive SP Short Form Guide
Issue Number: 1
Electrical Getting
Menu 0
Installation Started
The display consists of three lines of text.
The top line shows the drive status or the current
menu and parameter number being viewed on
the left, and the parameter value or the specific
trip type on the right.
The lower two lines show the parameter name or
the help text.
Figure 5-2 SM-Keypad Plus
Mode (black) button
Joypad
button is also used to reset the drive.
SM-Keypad
The decimal point after the
fourth digit in the upper display
will flash.
The decimal point after the
third digit in the upper display
will flash.
www.controltechniques.com
Running Advanced
the motor parameters
5.1.2

SM-Keypad Plus (LCD)

Control buttons
Fwd / Rev (blue) button
Stop/reset (red) button
Start (green) button
The symbol 'CC' will appear in
the lower left hand corner of
the display
The symbol 'Mot2' will appear
in the lower left hand corner of
the display
UL Listing
Diagnostics Appendix
Information
Mode (black) button
Help button
Joypad
SM-Keypad Plus
15