Control Techniques UNIDRIVE SP1201 Guía Rápida página 16

Safety Product Mechanical
Information Information Installation
viewed. The right and left functions on the joypad have no function when help text is
being viewed.
The display examples in this section show the SM-Keypad 7 segment LED display. The
examples are the same for the SM-Keypad Plus except that the information displayed
on the lower row on the SM-Keypad is displayed on the right hand side of the top row on
the SM-Keypad Plus.
Figure 5-3 Display modes
Status Mode
(Display not flashing)
To enter Parameter
Mode, press
Parameter Mode
(Upper display
flashing)
Use
to select parameter for editing
To enter Edit Mode,
press
* can only be used to move between menus if L2 access has been enabled (Pr
0.49). Refer to section 5.11 Parameter access level and security on page 20.
**Timeout defined by Pr 11.41 (default value = 240s).
Figure 5-4 Mode examples
Parameter
View Mode
Menu 5. Parameter 5
Pr 5.05 value
Do not change parameter values without careful consideration; incorrect values may
cause damage or a safety hazard.
WARNING
When changing the values of parameters, make a note of the new values in case they
NOTE
need to be entered again.
16
Electrical Getting
Installation Started
Timeout**
key or
When returning
to Parameter
Mode use the
keys to select
* keys
another parameter
to change, if
required
key
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values using
Healthy Status
www.controltechniques.com
Running Advanced
Menu 0
the motor parameters
Timeout**
To return to
Status Mode,
press key
*
To exit Edit Mode,
press key
keys.
Status Mode
Alarm Status
Unidrive SP Short Form Guide
UL Listing
Diagnostics Appendix
Information
Timeout**
Temporary Parameter
Mode
(Upper display flashing)
Trip Status
Drive status = tripped
Trip type (UU = undervolts)
Issue Number: 1