Control Techniques UNIDRIVE SP1201 Guía Rápida página 48

Safety Product Mechanical
Information Information Installation
Trip
SLX.Er Solutions Module slot X trip: Solutions Module in slot X has detected a fault
Automation module category
202,207,
212
Check value in Pr 15/16/17.50. The following table lists the possible error codes for the SM-
Applications and SM-Applications Lite.
Error code
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
Check value in Pr 15/16/17.50. The following table lists the possible error codes for the I/O
module.
Error code
0
1
74
48
Electrical Getting
Menu 0
Installation Started
User stack overflow
Unknown error
Parameter does not exist
Parameter read only
Parameter write only
Parameter value over range
Invalid synchronisation modes
Not Used
Sync lost with Virtual Master
RS485 not in user mode
Invalid RS485 configuration
Math fault
Array index out of range
Control word user trip
DPL program not compatible with this target
Processor overload/ Task Overrun
Invalid encoder configuration
Invalid timer unit configuration
Function block not supported by system
Corrupted Non-volatile flash
Drive rejected application module as Sync master
CTNet hardware error
Invalid CTNet configuration
CTNet baud rate does not match network
CTNet node ID already in use
Digital Output Overload
Invalid Function Block parameters
User Heap Requirement too large
File Does Not Exist
File Not Associated
Flash Access Failed during DB upload from drive
User Program download while drive enabled
Failed to change drive mode
Invalid CTNet Buffer Operation
Fast Parameter Initialisation Failure
Solutions Module over temperature
No errors
Digital output short circuit
Module over temperature
www.controltechniques.com
Running Advanced
Diagnostics
the motor parameters
Diagnosis
Reason for fault
Reason for fault
Unidrive SP Short Form Guide
UL Listing
Appendix
Information
Issue Number: 1