Troubleshooting
Problem
Very large or
yellow burner
flames
Control Display
Problem
Display goes
blank
Control panel not
responding
Oven
Problem
Oven not turning
on
Oven light not
turning on
Excessive smoke
during broiling
100
English
FULL_DOP36C86DLSDA_DG68-01507A-00_EN+MES+CFR.indb 100
FULL_DOP36C86DLSDA_DG68-01507A-00_EN+MES+CFR.indb 100
Possible causes
Wrong burner orifice
installed.
Possible cause
Bad fuse/tripped circuit
breaker.
Moisture/residue on panel;
Control Lock enabled.
Possible cause
Oven not fully plugged in.
Bad fuse/tripped circuit
breaker.
Oven controls improperly
set.
Oven too hot.
Incomplete service wiring.
Power outage.
Light loose/defective.
Broken light switch.
Oven controls improperly
set.
Meat too close to broil
element.
Meat not properly
prepared.
Grease buildup in oven.
Action
Check burner orifice size; if you have
wrong orifice (LP gas instead of
natural gas), call service technician.
Solution
Replace fuse/reset circuit breaker.
Remove moisture/residue, retry;
disable Control Lock.
Solution
Verify the range plug is properly
inserted in its outlet.
Replace fuse/reset circuit breaker.
See Using the Steam Oven, Pg. 74.
Let oven cool.
Call for service.
Check house lights. call utilities
provider if needed.
Tighten/replace lamp; call for service
if door light stays off.
Call for service.
See Using the Steam Oven, Pg. 74.
Lower the rack one level.
Trim excess fat from around meat.
Clean oven more frequently.
2023-02-23 오후 5:09:16
2023-02-23 오후 5:09:16